Residential Control Systems TR16 Installationsanleitung PDF herunterladen (Seite 15)

3. To use the Ai8_R13 to drive high voltage loads (120VAC or greater), use an external load relay to

separate the high voltage from the I/O module. Connect the wiring for driving a pump or heater as

follows:

4. An alternate method requires no 12-24 volts external volts for the coil. By using an RIB21CDC or

similar relay (available from Kele at www.Kele.com

), the 2 low voltage control wires can be

connected directly to the contact output of the A8_R13. See the following diagram for using this

method:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Residential Control Systems TR16 Installationsanleitung Seite 15